Knowledge
Home > Knowledge > Content
It is best to change regularly at the same time
- Apr 17, 2018 -

To see if the faucet has been adjusted, use a water-saving wrench to clockwise. After the final installation, open the main switch and check to see if there is any leakage.

Even if you tap the tap, you still leak water:

1. The reason for water leakage at the outlet: It is due to the worn shaft washers inside the faucet. Use a pair of pliers to loosen and remove the cover cap, remove the shaft washer with a clamp, and replace with a new shaft washer.

2. Causes of water leakage in the lower part of the faucet: It is caused by the wear of the triangular gasket in the gland. You can loosen the screw to remove the boring head, then loosen the pressure cap, and then remove the gland inside the gland and replace with a new one.

3. Water leakage at the joint joint: Generally the cap nut is loosened. At this point you can re-tighten the cap nut or replace it with a new U-shaped gasket.

If the water tap is found to have less water, it may be a water leakage situation because the single-headed faucet's water stop disk stuck the gravel. This kind of phenomenon is still looking for a professional maintenance division to dismantle the faucet to clean it, but if it is damaged, it must be replaced. In general, the correct use of a faucet means that the faucet should not be rotated too tightly so that the faucet pad can maintain a life of 7-8 years. However, the faucet of the hot water part tends to reduce its life due to thermal expansion and contraction. Therefore, it is generally recommended that the pads on both sides of the hot and cold are preferably replaced at the same time.